Filter
Top Products
101
RQT6035
Reference
³Insert the disc correctly with the label facing up. F
³This unit cannot play discs other than DVD-RAM, DVD-R, DVD-Video, Video CD, and CD. 6
³The disc is dirty. Clean it. ³
³The disc may be badly scratched. ³
³You inserted a blank DVD-RAM or DVD-R.
³Condensation has formed: Wait 1 to 2 hours for it to evaporate.
³Some operations may be prohibited by the disc.
³If the unit is not operating at all, press [ê/I, POWER] to switch the unit to standby, then press
[ê/I, POWER] again to turn the unit on. The unit may not be operating correctly due to lightning,
static electricity, or some other external factor.
³Some titles and chapters on DVD-Video are not played when you have changed the ratings level.
§
³Some distortion is normal.
³Change the settings for “3D NR”, “Block NR”, and “Mosquito NR” to “0” or turn MPEG DNR off
with the on-screen menu icons. Z
³The languages are not recorded on the disc.
³You may have to use the disc’s menus to select languages. G
³Subtitles are not recorded on the disc.
³Turn the subtitles on. Y
³This function depends on software availability. Angles can only be changed during scenes where
different angles are recorded (“” appears on the display).
³Return the ratings setting to “8”.
While the disc tray is open, press and hold [:] and [9] on the main unit at the same time for
5 or more seconds.
Play fails to start even when
[1, PLAY] is pressed.
Play starts but then stops
immediately.
“U11”, “NO DISC”, or “NO PLAY”
appears on the unit’s display.
No response when buttons
pressed.
A title or chapter doesn’t play
when it is selected.
Picture distorted during search.
There is ghosting.
Alternative soundtrack and
subtitles cannot be selected.
No subtitles.
Angle cannot be changed.
You have forgotten your ratings
password.
³Go to Display in the ACTION menus and change the display’s brightness with “FL Display”. ¤
³The clock is not set.
Go to Set Up in the ACTION menus and set the clock with “Clock Settings”. ¨
The display is dim.
“12:00” is flashing on the unit’s
display.
Displays
Play
³[DVD, TV] is not switched to “DVD”.
Switch to “DVD” when operating this unit. 8, <
³The remote control and main unit are using different codes.
Change the code on the remote control or main unit. ¢, £
³The batteries are depleted. Replace them with new ones. <
³Point the remote control at the remote control sensor on the main unit. <
³Remove obstacles from between the remote control and main unit.
³Change manufacturer code. Some televisions cannot be operated even if you change the code.
=
³[DVD, TV] is not switched to “TV”.
Switch to “TV” when operating the television. 8
The remote control doesn’t work.
Cannot operate the television.
Remote control