Filter
Top Products
17
RQT6035
Getting started
Plug-in Auto Tuning
Note
³Plug-in Auto Tuning does not work if you turn the unit on by press-
ing [<, OPEN/CLOSE] or [1, PLAY].
³After the unit sets the clock automatically, it then adjusts the clock
everyday.
³If the unit sets the time incorrectly, use “Time Zone Adjust” to cor-
rect it (➡ page 89).
³You can give the stations captions (➡ page 92).
³If you connect the unit through a cable TV box or DSS receiver
(➡ page 76), tune to your local PBS station before starting auto
clock setting. Use manual clock setting (➡ page 88) if this does not
work.
³If there is no local PBS channel in your area then Auto Clock Set-
ting may not work correctly. In this case the time must be set man-
ually (➡ page 88).
º Channel plan
The unit automatically determines the type of transmission (airwave
or cable) and puts them into channels as follows.
³TV Mode
º To start Plug-in Auto Tuning again (after moving
house, for example)
Main unit only
While the unit is on and stopped
1. Press and hold [X, CH] and [W, CH] for about five seconds.
³The unit turns off.
2. Press [ê/I, POWER] to turn the unit on.
The screen shown in step 1 on page 16 appears. Press [ENTER] to
start Plug-in Auto Tuning.
³Antenna system, channel caption, and VCR Plusi guide channel
settings all revert to the default values when you perform the
above procedure. Timer recording settings are also cleared.
Band
VHF
UHF
Stations received by
airwaves
2–13
14–69
³CATV Mode
Band
VHF
CATV LOW BAND
CATV MID/SUPER BANDS
CATV HYPER BAND
ULTRA BAND
SPECIAL CATV CHANNEL
Stations received by cable
2–13
95–99
14–36
37–65
66–94
100–125
1
ENTER
Í/I,POWER
,CH,