Filter
Top Products
86
RQT6035
Initial settings
Entering a password
You can limit play of DVDs unsuitable for some audiences. Play and
changes to the settings are not possible unless you enter a
password.
When setting ratings
The password screen is shown when you select levels 0 to 7.
1. Input a 4-digit password with the numbered buttons.
³If you enter a wrong number, press [CANCEL] to erase it before
you press [ENTER].
Do not forget your password.
2. Press [ENTER].
3. Press [ENTER].
The password is entered and the unit is locked.
Changing the unit’s settings
Now, when you insert a DVD-Video that exceeds the ratings
limit you set, a message appears on the television.
Follow the on-screen instructions.
Digital output
Change these settings when you have connected equipment
through this unit’s OPTICAL DIGITAL AUDIO OUT terminal.
PCM Down Conversion
Off (factory setting):
When you have used audio cables to connect the unit to other
equipment (analog connection [C] ➡ page 78).
On:
When you have used an optical digital cable to connect the unit to
other equipment (digital connection [B] ➡ page 78). Output is limited
to 48 kHz/16 bit.
Output of audio with a sampling frequency of 96 kHz
Audio is output as follows in accordance with the connections and
settings you make.
Connection
Setting
Off
On
[C]
(analog)
Output as 96 kHz
Converted and output
as 48 kHz
[B]
(digital)
No output
¤1
Converted and output
as 48 kHz/16 bit
¤1
96 kHz audio is output if the DVD is unprotected, but the connect-
ed equipment must be able to handle such signals in order to play
them.
Dolby Digital
Bitstream (Factory preset):
When you have connected a unit with a built-in Dolby Digital
decoder.
PCM:
When you have connected a unit that doesn’t have a built-in Dolby
Digital decoder.
¤2
DTS
Off (Factory preset):
When you have connected a unit that doesn’t have a built-in DTS
decoder.
¤2
Bitstream:
When you have connected a unit with a built-in DTS decoder.
¤2
Set “Dolby Digital” to “PCM” and “DTS” to “Off” if the other equip-
ment doesn’t have decoders. Incorrect settings can cause noise
to be output which can be harmful to your ears and speakers, and
audio will not be recorded properly to digital recording equipment.
ACTION
No.
0
-
9
RETURN
Ratings
Enter a 4 digit password,
then press ENTER
Password
✱✱✱✱
ACTION
Ratings
Unlock Recorder
Change Password
Change Level
Temporary Unlock
RETURN
ENTER
SELECT
When changing ratings
The password screen is shown when you select “Ratings”.
1. Input your 4-digit password with the numbered buttons and press
[ENTER].
Unlock Recorder: To unlock the unit and return the rating to 8
Change Password: To change your password
Change Level: To change the rating level
Temporary Unlock: To temporarily unlock the unit (the unit
locks again if you switch it to standby or
open the disc tray)
2. Select the item with the joystick [3, 4] and press [ENTER].
Actual screens depend on the operation. Follow the on-screen
instructions.
!?