Filter
Top Products
1-1 Features
Chapter 1 Overview
1-4 Chapter 1 Overview
..........................................................................................................................................................................................................
1) LTC (Longitudinal Time Code)
Time code recorded on a longitudinal track
VITC (Vertical Interval Time Code)
Time code recorded on a video track during
the vertical blanking interval
DMC (Dynamic Motion Control) editing
Using the DT
®
(Dynamic Tracking ) heads, you can
play back a section of an edit at speeds between –1 and
+3 times normal speed, and store the speed variation in
memory for later use in automatic editing.
Split editing
In insert mode, you can set audio and video edit points
separately.
Preread editing
You can perform preread editing using video or digital
audio signals recorded on the tape as the edit source
for insert editing.
A variety of audio editing modes
You can select cut-in editing, cross-fade editing, and
fade in/out editing for the audio signals.
Display of duration between edit points
After edit point data have been set, you can display the
duration between any two IN, OUT, AUDIO IN, or
AUDIO OUT points by simultaneously pressing two
buttons corresponding to those edit points.
Digital time counter
The time counter display shows CTL and time codes
(LTC/VITC
1)
), or user bits data to enable the precise
setting of edit points.