Filter
Top Products
Chapter 6 Editing 6-19
Chapter 6 Editing
6-3 Manual Editing
Follow the procedure below to perform manual
editing.
Manual editing
1 After pressing the RECORDER button, enter jog
or shuttle mode to position the tape at a place a few
seconds before the position at which you want to
set an edit point.
2 Press the [F3] (ASSEMBLE) button in the HOME
menu or press the respective INSERT button ([F4]
(INS TC), [F5] (INS VIDEO), [F6] (INS A-CH1),
[F7] (INS A-CH2), [F8] (INS A-CH3), [F9] (INS
A-CH4) or [F10] (INS CUE) button) to select the
edit mode that you want.
3 Press the PLAY button.
Playback starts.
4 Press the PLAY button while holding down the
EDIT button at the point where you want to start
editing (IN point).
Editing starts.
5 Press the PLAY button where you want to end
editing (OUT point).
Editing ends, but the tape continues to run in
playback mode.
6 Press the STOP button to stop the tape.
Notes
•Noise will appear on the picture at the IN or OUT
point if you start editing while the VTR is stopped, or
if you stop editing by pressing the STOP button.
• To ensure a stable picture, start playback at least two
seconds before the IN point.
14
6
3,52