Filter
Top Products
3-2 Chapter 3 Setting Up the VTR
3-1 Connecting External Equipment
Chapter 3 Setting Up the VTR
Making analog connections
The diagram below shows how to make connections
for analog video and audio signals from a Betacam/
Betacam SP VTR, 1-inch VTR, or D-2 VTR.
3-1-2 Making Analog Connections
DVR-28/20 D-2 VTR or
BVH-3000 1-inch VTR etc.
(player)
ANALOG AUDIO
OUTPUT CH-1 to 4
ANALOG VIDEO
OUTPUT
COMPONENT
VIDEO
OUTPUT
Video monitor
9-pin remote cable
BNC cable
BNC cable
BNC cable
COMPOSITE VIDEO INPUT
(with BKDW-505/506)
ANALOG AUDIO INPUT CH-1 to 4
REMOTE (9P)
AUDIO
OUTPUT CH-1
to 4
REMOTE (9P)
Set the analog audio input level and impedance
using the AUDIO INPUT LEVEL/600Ω termination
switches as follows:
For line input with a 600Ω termination: HIGH with
ON
For high-impedance line input: HIGH with OFF
For high-impedance microphone input: LOW with
OFF
COMPONENT VIDEO INPUT
BVW-75/70/65/60 series
Betacam SP VTR (player)
COMPONENT or
COMPOSITE VIDEO OUTPUT
Set the 75Ω
termination
switch to OFF
when making a
bridge
connection for
an analog
composite video
signal.
Otherwise, set it
to ON.