Filter
Top Products
Chapter 4 Menu Settings 4-39
Chapter 4 Menu Settings
Selecting remote operation mode
When operating the VTR with an external device, set
the [F8] (REMOTE 9-PIN) button or [F9] (REMOTE
50-PIN) button to on.
When the [F8] (REMOTE 9-PIN) button is set to
on
You can operate the VTR with a device connected to
the REMOTE1-IN(9P)/OUT(9P) connectors.
When the [F9] (REMOTE 50-PIN) button is set
to on
You can operate the VTR with a device (optional
BKDW-509) connected to the REMOTE PARALLEL
I/O(50P) connector.
Note
When operating the VTR through an external device,
all of the tape operation and editing buttons are
disabled, with the exception of the STOP and EJECT
buttons. You may also set the VTR so that all buttons
are enabled or disabled. Perform this setting through
006. LOCAL FUNCTION ENABLE of the VTR
SETUP menu. You cannot, however, disable the menu
and remote operation mode selection buttons.
Setting the test signal
To turn on the internal test signal generator, press the
ALT button, then set the [F9] (AUDIO SG) button to
on, or press the ALT button, then set the [F10]
(VIDEO SG) button to on.
Select the audio test signal through 808. INTERNAL
AUDIO SIGNAL GENERATOR and the video test
signal through 710. INTERNAL VIDEO SIGNAL
GENERATOR in the VTR SETUP menu.
Note
Setting the test signal to OFF in item 710 or 808 in the
VTR SETUP menu turns off the [F9] (AUDIO SG)
button or [F10] (VIDEO SG) button, respectively.
To turn on the test signal generator, select the test
signal on respective item again, turning on the [F9]
(AUDIO SG) button or [F10] (VIDEO SG) button.