Filter
Top Products
4-4 CUE Menu
4-32 Chapter 4 Menu Settings
Chapter 4 Menu Settings
4-4-6 Backspace Editing
You can perform backspace editing with the CUE
menu. In backspace editing, assemble editing is
performed from the recording end point. Since the
data specifying recording end point are cleared when
you eject the tape, after inserting a tape, you must
record for at least one minute or so on the tape before
you can do backspace editing. After recording, the
present end of the recorded position becomes the
recording end point. When you press the AUTO
EDIT button afterwards, the VTR automatically
prerolls a few seconds before the recording end point
and starts assemble editing. If no data for the
recording end point exist, backspace editing is not
performed.
4-4-5 Changing a Cue Point Into
an Edit Point
Follow the procedure below to change any cue point
into an edit point.
To change an edit point into an IN point
Press the SET button while hoding down the IN
button.
To change an edit point into an OUT point
Press the SET button while holding down the OUT
button.
To change an edit point into an AUDIO IN
point
Press the SET button while holding down the AUDIO
IN button.
To change an edit point into an AUDIO OUT
point
Press the SET button while holding down the AUDIO
OUT button.
AUDIO OUT button
SET button
AUDIO IN button
OUT button
IN button