Filter
Top Products
Menu List
A-32 Appendix
Appendix
Item Settable range
805
AUDIO MONITOR
OUTPUT MIXING
Item number
Specifies the type of audio mixing to be conducted on the
digital audio signal or Betacam playback analog audio
signal output to the MONITOR OUTPUT connector.
0: Simple addition
1: Multiplied average
2: Simple average
Note
When the CUE channel signal (a digital Betacam analog
audio signal) is output to the monitor, signals are mixed by
simple addition.
add
[rms]
average
0
[1]
2
Specifies the mode in which the digital audio level is
displayed.
0: Displays minus audio levels with the maximum level set
at 0 dB.
1: Displays plus and minus audio levels with the reference
level set at 0 dB.
Note
The cue channel level is always displayed with the
reference level set at 0 dB. In the Betacam playback mode,
all channel levels are displayed with the reference level set
at 0 dB no matter what this setting is.
LEVEL METER
SCALE
806
[0]
1
[peak0dB]
reference 0 dB
Sets the output timing for the digital audio playback signal
(SIF and AES/EBU only). The 80H setting specifies the
reference position.
A setting lower than 80H advances the output timing, and a
setting higher than 80H delays the output timing.
(80H = 128 samples, or approx. 2.7 ms, with 1 sample =
approx. 20 µs)
807 AUDIO OUTPUT
PHASE
preset: 80H
0
I
[80]
I
FF
Function
808 INTERNAL AUDIO
SIGNAL
GENERATOR
[0]
1
2
Specifies the operation of the internal audio test signal
generator.
0: The internal audio test signal generator does not oprate.
1: Silent signal
2: 1 kHz signal output (1 kHz –20 dB FS sine wave is
supplied to all audio inputs.)
In modes other than off:
• Press the INPUT SELECT button on the upper control
panel so that it lights up (the VTR enters AUDIO INPUT
SELECT mode).
• When one of the CH1 AUDIO INPUT SELECT buttons
(SIF, AES/EBU L, ANALOG R) is held down for more than
three seconds, the digital audio input signals of all
channels are replaced by the internal audio signal.
0 (HEX)
I
80 (HEX)
I
FF (HEX)
[off]
silence
1 kHz sine