Filter
Top Products
Chapter 6 Editing 6-7
Chapter 6 Editing
6-1-6 Cuing Up and Prerolling
You can preroll the tape to a point prior to the edit start
point (preroll point), or cue up the tape to any edit
point.
When prerolling the tape during split editing, the VTR
regards the earliest IN or AUDIO IN point as the edit
start point.
Follow the procedure below to cue up or preroll the
tape.
Cuing up and prerolling
1 Press the RECORDER or PLAYER button to
select the VTR which you want to operate.
The button lights up.
2 • To cue up the tape to an edit point
Press the IN, OUT, AUDIO IN, or AUDIO OUT
button while holding down the PREROLL
button.
The tape moves to the edit point corresponding
to the button, then stops.
• To preroll the tape
Press the PREROLL button.
The tape is rewound to a point five seconds prior
to the edit start point.
Note
When the [F1] (TIMER SEL) button in the TC menu is
set to CTL, cuing up is slightly slower than in TC
mode. This is to maintain the accuracy of the CTL
signals.
You can set up the VTR so that priority is placed on
cuing accuracy or speed. Change the VTR setting
through 404. CUEUP BY TC and 405. CUEUP BY
CTL in the VTR SETUP menu.
6-1-5 Confirming Edit Points
You can confirm the duration between two edit points
in the display.
Displaying the duration between two edit
points
The following six kinds of duration can be displayed in
the time data display window:
•Between IN and OUT points
•Between IN and AUDIO OUT points
•Between IN and AUDIO IN points
•Between OUT and AUDIO OUT points
•Between OUT and AUDIO IN points
•Between AUDIO IN and AUDIO OUT points
The displayed duration differs for each of the
following cases:
•When two edit points are set: duration between the
two points
•When only one of the edit points is set: duration
between the set edit point and the current tape address
•When no edit points are set: duration of the previous
edit section
To display the duration, follow the procedure below.
1 Press the RECORDER or PLAYER button to
select the VTR for which you want to confirm a
duration.
The button lights up.
2 Hold down any two IN, OUT, AUDIO IN, or
AUDIO OUT buttons.
The duration between the points corresponding to
the two buttons is displayed. The value can be
negative.
Displaying the duration between two edit points
1
2
Duration
between two
edit points
ÅIN 00:00:00:00 ÅOUT 00:00:00:00
LOCK
DOLBY
NR
TIMER
SEL
TC
CH.COND
GREEN
DIGITÅL
TC
DUR VITC PLÅY 4FD F1
IN 01:00:30:00 OUT 01:00:00:00
00Ó 00µ 30ß 00ƒ
TIMER
RESET
TIMER
SET
TIMER
HOLD
off
TC
SEL
VITC
TCG
SOURCE
int
TCG
MODE
prst
RUN
MODE
rec
DF/NDF
df
VITC
on