Filter
Top Products
Installation
Rev 3.03 6 Document 900.0315
02/07
Figure 2-1 DVR Rear Panel
Connecting the Video Source
Figure 2-2 Video Input Connectors
Connect the coaxial cables from the video sources to the BNC Video In connectors.
Connecting the Loop Through Video
Figure 2-3 Video Loop Through Connectors
If you would like to connect your video source to another device, you can use the Loop
BNC connectors.
VIDEO IN 1
LOOP 1
AUDIO IN 1
VIDEO IN 2
LOOP 2
AUDIO IN 2
VIDEO IN 3
LOOP 3
AUDIO IN 3
VIDEO IN 4
LOOP 4
AUDIO IN 4
AI1 AI2 AI3 AI4 GND ARI RX+ RX-
NC C NO NC C NO TX+ TX-
VIDEO OUT
SVHS OUT
AUDIO OUT
RISK OF ELECTRIC SHOCK
DO N OT OPEN
CAUTION:TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO U SER-SER VICEABLE PART S INSIDE.
REFER SERVICING TO QUALIFIED
SERVIC E PERSONNEL
VGA
100-240 V ~ 50/60 Hz, 2 A
VGA NETWOR K R5 - 232C
CVBS
SVHS
!
CAUTION
Video in
Video out
SVHS out
Alarm in
RS485 port
Power connector
VGA port
RS232C port
Audio in
Audio out Alarm out
Ethernet port Factory reset
switch
CVBS (SVHS) or VGA
selector switch
VIDEO IN 1 VIDEO IN 2 VIDEO IN 3 VIDEO IN 4
LOOP 1 LOOP 2 LOOP 3 LOOP 4