Filter
Top Products
Configuration
Rev 3.03 37 Document 900.0315
02/07
Figure 3-22 Motion Detection Zone Screen
The Motion Detection Zone screen is laid over the video for the selected camera. You
can set up motion detection zones by selecting or clearing blocks.
Note You can activate or deactivate four cells at a time using the
button. After four cells are highlighted, if you hold the button
down until the color of the highlighted cell changes from blue to
yellow, you can select individual cells by using the camera
buttons.
Press Menu on the front panel to open the Motion Detection Zone menu. The menu
choices are described as follows:
Text In Setup Screen
Use the Text-In Setup screen to set the DVR to display the text-in information. Highlight
Text-In in the Device menu (MENU
➤ Device ➤ Text-In) and then press . The
Text-In setup screen displays.
Table 3-2 Motion Detection Zone Choices
Menu choice Description
Exit with save Closes the menu after saving the changes.
Exit without save Closes the menu without saving the changes.
Select All Blocks Activates all blocks to detect motion.
Clear All Blocks Deactivates all blocks so that they will not detect motion.