Filter
Top Products
Operation
Rev 3.03 81 Document 900.0315
02/07
Preset View
After you have set the camera presets, you can go directly to the desired views.
1. Press QUAD/SEQ to load the Preset View dialog box.
2. Select the desired preset number to load the preset.
Figure 4-5 Preset View Screen
Digital Zoom Mode
You can enter Digital Zoom mode by pressing the PTZ button on the front panel while
in PTZ mode.
Note You cannot enter Digital Zoom mode when the DVR detects
video loss on the selected camera or the camera is turned off or
set up as Covert 1 or Covert 2.
After you are in Digital Zoom mode, a bright small box is laid over the image. The box
indicates the spot to be enlarged. To enlarge the spot, move the position of that box
using the Arrow buttons, and then press . The enlarged screen displays . Pressing
PTZ again returns the DVR to Live Monitoring mode.
Recording Video
After you have installed the DVR following the instructions in Chapter 2, Installation, it is
ready to record. Unless you change the setup, the DVR continues to record until the
hard disk drive is full. The factory default is Stop when the hard disk drive is full. The
DVR can be set to continue recording (Overwrite) after the hard disk drive is full. It does
this by recording over the oldest video.