Filter
Top Products
Configuration
Rev 3.03 63 Document 900.0315
02/07
The factory default Port settings are:
Note The system restarts automatically after changing the port
settings.
Note Do NOT use the same port number for two different programs,
otherwise, the DVR cannot be connected with a PC running RAS.
Caution When changing the port settings, you must change the port
settings on the PC running RAS as well. Refer to the Remote
Administration System (RAS) User Guide for details.
To save your changes and return to the Network Setup screen, highlight OK and then
press . Select Cancel to exit the screen without saving the changes.
LAN — DHCP
Selecting DHCP from the Type box on the LAN Setup screen, and highlighting OK
reads the current IP Address of the DVR configured by the DHCP (Dynamic Host
Configuration Protocol) network.
Remote Admin: 8200
Remote Watch: 8016
Remote Search: 10019
Remote Callback: 8201