Filter
Top Products
Configuration
Rev 3.03 29 Document 900.0315
02/07
Note When the time difference between the DVR and the time server is
more than one minutes, the DVR might not synchronize the time
to prevent any unexpected loss of recorded video data. If you
want to synchronize the time manually, select Now… .
Highlight the Run as Server box and then press to toggle between On and Off. When
it is On, the DVR you are setting up runs as a time server.
To save your changes, highlight OK and then press . Select Cancel to exit the screen
without saving the changes.
Highlight the box beside Date Format and press . A list of date formats displays.
Highlight the format you wish to use and then press . The choices are:
MM-DD-YYYY
DD-MM-YYYY
YYYY-MM-DD
MM/DD/YYYY
DD/MM/YYYY
YYYY/MM/DD
To change the time format, highlight the box beside Time Format and then press .
The DVR toggles between 12 Hours (AM/PM) and 24 Hours (military time).
To save your changes, highlight OK and then press . Select Cancel to exit the screen
without saving the changes.
System Check Screen
Use the System Check screen to check the status (fault condition) of the DVR. Highlight
System Check in the Main Menu (MENU ➤ System ➤ System Check) and then
press . The System Check setup screen displays.
Figure 3-12 System Check (Config) Screen