Sony AT200 DVD Recorder User Manual


 
140
, The Synchro-Recording and another timer
recording overlap (page 64).
Synchro-Recording does not complete.
, The timer setting for the connected
equipment overlapped the recorder’s timer
setting (page 64).
, There was a power failure during the
recording.
, The [/1 button was pressed before
Synchro-Recording started.
The recorder automatically starts
recording when the satellite receiver is
turned on.
, The Synchro Rec function was activated.
Turn off the satellite receiver and cancel
the Synchro Rec function (page 64).
You dubbed a title, but the title did not
appear in the HDD Title List.
, The title contained a copy protection
signal, so it was moved (page 150).
High-speed dubbing is not possible.
, The title cannot be dubbed at high speed
(page 84). Even if A-B erasure is
performed so that a title does not contain
mixed picture sizes, it is still treated as a
title with mixed picture sizes.
HDD/DVD Dubbing is not possible.
, The title cannot be dubbed (page 83).
HDD camcorder dubbing is not possible.
, An HDD camcorder which is not
supported by this recorder is connected
(page 87).
, The HDD camcorder is not set to the USB
connection mode (page 88).
, The HDD camcorder contains only the
contents that have already been dubbed to
the recorder when you are dubbing using
the ONE-TOUCH DUB button or
“Incremental Dubbing.”
The clock has stopped.
, Set the clock again (page 117).
The clock is wrong.
, Set the clock again (page 117). If you
cannot set the clock, wait until the clock
data is received and the clock is
automatically adjusted.
The timer indicator is flashing.
, The disc does not have enough space.
, Insert a recordable disc into the recorder.
, The inserted DVD is protected (page 42).
The clock does not appear in the front
panel display when the recorder is turned
off.
, “Front Panel Display” is set to “Off” in the
“Options” setup (page 132).
The remote does not function.
, Different command modes are set for the
recorder and remote. Set the same
command mode (page 132). The default
command mode setting for this recorder
and the supplied remote is “3 (Default
setting).” You can check the current
command mode in the front panel display
(page 132).
, The batteries are weak.
, The remote is too far from the recorder.
, The remote’s manufacturer code returned
to the default setting when you replaced
the batteries. Reset the code (page 23).
, The remote is not pointed at the remote
sensor on the recorder.
The recorder does not detect a USB
device connected to the recorder.
, Make sure that the USB device is securely
connected to the recorder (page 133).
, Check if the USB device or a cable is
damaged.
, Check if the USB device is on.
Dubbing
Display
Remote control
Others