Filter
Top Products
35
Seven Basic Operations — Getting to Know Your DVD Recorder
2. Recording a
Programme
This section introduces the basic operation
to record a current TV programme to the
hard disk (HDD) or to a disc (DVD). For an
explanation of how to make timer
recordings, see page 52 (for RDR-AT105/
AT107/AT205) or page 58 (for RDR-
AT100/AT200).
1 Press HDD or DVD.
If you want to record to a DVD, insert a
recordable DVD.
2 Press PROG +/– to select the
programme position or input source
you want to record.
3 Press REC MODE repeatedly to select
the recording mode.
Each time you press the button, the
display on the TV screen changes as
follows:
* Available when “Manual Rec. Mode” is set
to “On (go to setup)” in the “Recording”
setup (page 127).
For more details about the recording
mode, see page 147.
4 Press z REC.
Recording starts.
To stop recording
Press x REC STOP.
To pause recording
Press X.
To resume recording, press X again.
To watch another TV programme while
recording
If your TV is connected to the T LINE 3 –
TV jack, set your TV to the TV input using
the TV/DVD button and select the
programme you want to watch. If your TV is
connected to the LINE 2 OUT or
COMPONENT VIDEO OUT jacks, set the
TV to TV input using the TV
t button
(page 23).
TV Direct Rec. (for SMARTLINK
connections only)
When the TV is turned on and the recorder is
turned off, press TV PAUSE. The recorder
automatically turns on and starts recording
what you are watching on the TV to the
HDD.
Set “TV Pause” to “TV’s Tuner” in the
“Options 2” setup (page 133).
+
RW
-
RWVR
-
RW
Video
+
R
HDD
-
RVR
-
R
Video
HDD DVD
PROG +/–
REC MODE
z REC
x REC
STOP
X
,continued