Filter
Top Products
146
Advanced Disc Playback
Customizing disc playback
3 Use the Channel Number buttons (0–9) to input the current
password.
If the password has not been set yet, key in “0000.” This is the
factory default password.
4 Use the Channel Number buttons (0–9) to input the new
password.
You will be prompted to confirm the new password.
5 Use the Channel Number buttons (0–9) to input the new
password again.
6 Note this new password for future reference.
If you forget the system password:
1 Make sure there is no disc in the disc slot.
2 Press and hold down the VOLUME (–) button on the TV
control panel, and then press the number 4 button on the
remote control for a few seconds.
The “Initializing” message appears on-screen to indicate that
the password has been reset to its default factory setting
“0000.” All DVD Setup related settings will also be reset to
their default factory values.
Spdif Output (Digital Out)
Select the sound format of the digital output depending on the
enabled signal connection.
❖ Spdif/Raw: Select this option to output the signal in its native
format.
❖ Spdif/Pcm: Changes Dolby
®
Digital output to PCM. Select
this option when using a two-channel digital stereo amplifier.
MPEG audio will always be in PCM format regardless of the Digital
Output setting.
NOTE