Filter
Top Products
55
Setting up your TV
Setting the HDMI® audio mode
2 Press the ( / arrow) buttons to select a channel position to
be locked, and then press the OK button. Enter your four-digit
PIN code.
A check appears in the box. To remove the check, press the OK
button again.
If the PIN code has not been set yet, a warning message appears.
3 To save the setting, press the EXIT button.
To manually add digital sub-channels on a physical channel:
Use the Channel Numbers and the Dash/100 button on the remote
control to enter the channel number (for example, 56–1). If the
channel is found, the number will be added to the list and the box
will be unchecked.
If the channel is not found, a message appears.
Skipped channels cannot be selected with the CH Up/Down arrow)
buttons; however, they can be accessed using the number keys on
the remote control.
To remove encrypted channels from the channel memory:
If an encrypted channel is accidentally added to the channel list
while programming channels, you can remove the unwanted
encrypted (non-viewable) channel while you are channel surfing.
When you tune to an encrypted channel, the following message
appears.
(Sample Illustration) Removing an encrypted channel
Press the 1 button while the message is displayed to remove the
unnecessary channel from the channel list.
Setting the HDMI
®
audio mode
To set the HDMI
®
audio mode:
1 Press the MENU button to open the Sound menu.
2 Highlight Audio Setup, and then press the OK button.
NOTE
NOTE