Filter
Top Products
Chapter 1 Introduction
EOC350 Series User’s Guide
11
1.2.1 LEDs
The following table describes the EOC350-TS LEDs.
Note: None of the LEDs are on if the EOC350-TS is not receiving power.
1.2.2 Connections
Figure 3 EOC350-TS Connections
Table 1 EOC350-TS LEDs
LED DESCRIPTION
DIAG This LED turns on when you configure the EOC350-TS to check the Ethernet over Coaxial
connection with an EOC350-TA. If the LED is dim then no EOC350-TA has been found in the
Ethernet over Coaxial cable network.
QLTY This LED shows the Ethernet over Coaxial cable speed. green is high, orange is medium
and red is low. If the LED suddenly becomes red, there may be noise interference. Check
the web configurator for further information.
LINK/ACT This LED is steady green when there is an Ethernet over Coaxial connection and blinks
when there is traffic.
2 This LED is steady green when there is an Ethernet connection and blinks when there is
traffic. This LED is steady orange when there is a Gigabit Ethernet connection and blinks
when there is traffic.
1 This LED is steady green when there is an Ethernet connection and blinks when there is
traffic. This LED is steady orange when there is a Gigabit Ethernet connection and blinks
when there is traffic.
PWR This LED is on green when the EOC350-TS is receiving power.
POWER
12V DC-IN
POWER
12V DC-OUT
2
RESET
IN
OUT
1
Power
LAN 1
LAN 2
Link/Act
Quality
Diagnosis
POWER
12V DC
LINE
Power Switch
Power Out
OUT
IN
Reset
Ethernet PortsPower In