Filter
Top Products
Chapter 5 EP Management
EOC350 Series User’s Guide
33
The following table describes the items in this screen.
5.7.4 The IGMP Screen
Use this screen to enable IGMP v1/2 fast leave on the termination adapter’s interfaces. Click EP
Management > Ether > Config > IGMP on the default profile to show the following screen.
Figure 24 EP Management > Ether > Config > IGMP (profile)
The following table describes the items in this screen.
5.7.5 The VLAN Screen
Use this screen to configure VLAN tagging on the termination adapter’s interfaces. Click EP
Management > Ether > Config > VLAN on the default profile and then select Enable from Tag
VLAN to show the following screen.
Table 20 EP Management > Ether > Config > QoS (profile)
LABEL DESCRIPTION
Priority base
on
Select 802.1p to configure the IEEE 802.1p prioritization scheme for incoming frames.
Select IP TOS/TC or DSCP to configure the IP prioritization scheme.
Queue
Scheduling
Select Strict Priority to forward packets in the higher priority queues first (Q0 has the
lowest priority). Packets in the lower priority queues will be forwarded after the higher
priority queues are empty.
Select Weight fair Queue to forward 8 packets from Q3, then 4 packets from Q2, then 2
packets from Q1, and then 1 packet from Q0.
Select Mix mode to use strict priority to forward packets from Q3 first, and weighted fair
queuing to forward packets from Q2, Q1, and Q0.
Port Type a TCP/UDP port number to prioritize traffic for important applications.
Queue Select a queue for this port.
Apply Click Apply to save your settings.
Back Click Back to return to the previous screen.
Table 21 EP Management > Ether > Config > IGMP (profile)
LABEL DESCRIPTION
IGMP Snooping Select Enable to enable IGMP v1/2 fast leave. Select Disable if only IGMP v3 is
implemented on the network.
Apply Click Apply to save your settings.
Back Click Back to return to the previous screen.