Filter
Top Products
Chapter 5 EP Management
EOC350 Series User’s Guide
28
The following table describes the items in this screen.
5.5.5 The VLAN Screen
Use this screen to configure VLAN tagging on the termination system’s interfaces. Click EP
Management > Ether > Config > VLAN on the local termination system device and then select
Enable from Tag VLAN to show the following screen.
Figure 17 EP Management > Ether > Config > VLAN (termination system)
The following table describes the items in this screen.
Table 15 EP Management > Ether > Config > IGMP (termination system)
LABEL DESCRIPTION
IGMP Snooping Select Enable to enable IGMP v1/2 fast leave. Select Disable if only IGMP v3 is
implemented on the network.
Apply Click Apply to save your settings.
Back Click Back to return to the previous screen.
Table 16 EP Management > Ether > Config > VLAN (termination system)
LABEL DESCRIPTION
Cascade Mode
Tag V LAN Select Enable to enable VLAN tagging.
Port
This shows the port name for this row.
Priority
Select the 802.1Q priority applied to incoming frames.
VID
Select the 802.1Q VLAN ID applied to incoming frames.
In Rule
Select Accept All to forward all incoming frames regardless of VID. Select VID Matched to
forward only the incoming frames that match the port VID.
Out Rule
Select Tag to add an 802.1Q tag to egress frames. Select Untag to remove the 802.1Q tag
from egress frames. Select Bypass to leave the tag of the frame alone.
Apply Click Apply to save your settings.
Back Click Back to return to the previous screen.