Filter
Top Products
Chapter 5 EP Management
EOC350 Series User’s Guide
35
The following table describes the items in this screen.
5.8 EP Configuration
This section describes the screens that configure the default profile for termination adapters.
5.8.1 The EoC Screen
Use this screen to restrict how many hosts can send and receive data through the termination
adapter. Click EP Management > Ether > Config on the termination adapter to show the
following screen.
Figure 27 EP Management > Ether > Config (termination adapter)
The following table describes the items in this screen.
5.8.2 The Port Screen
Use this screen to throttle the bandwidth of the termination adapter’s interfaces. Click EP
Management > Ether > Config > Port on the termination adapter to show the following screen.
Table 23 EP Management > Ether > Config > Filter (profile)
LABEL DESCRIPTION
Allowed Host
MAC
This shows the hosts that are allowed to send and receive traffic via the EP. If no hosts are
listed then all hosts are allowed, otherwise only the listed hosts are allowed.
Add Type a MAC address and then click Add to add a host to the Allowed Host MAC list.
Del Click Del to delete a host from the Allowed Host MAC list.
Back Click Back to return to the main EP Management screen.
Table 24 EP Management > Ether > Config (termination adapter)
LABEL DESCRIPTION
Note Type a note here.
Host Limit Type the maximum hosts allowed to connect to the termination adapter. Service is disabled if
this is 0.
Apply Click Apply to save your settings.
Back Click Back to return to the main EP Management screen.