Filter
Top Products
EOC350 Series User’s Guide 19
CHAPTER 3
System Setup
3.1 Overview
This chapter describes how to configure the IP and DHCP Snooping parameters of the Ethernet
interface facing the Internet Service Provider (ISP).
3.2 The System Setup Screen
Use this screen to configure the IP and DHCP Snooping parameters. Click System Setup to show
the following screen.
Figure 8 System Setup
The following table describes the items in this screen.
Table 7 System Setup
LABEL DESCRIPTION
IP Address
Assignment
Select Static to enable manual IP configuration or Dynamic (DHCP) to enable the EOC350-
TS to get its IP configuration via the Dynamic Host Configuration Protocol (DHCP).
IP Address Enter the IP address you want to assign to your EOC350-TS in dotted decimal notation, for
example, 192.168.1.1 (factory default).
Subnet Mask Type the subnet mask of your network in dotted decimal notation, for example
255.255.255.0 (factory default). Your EOC350-TS automatically computes the subnet mask
based on the IP address you enter, so do not change this field unless you are instructed to do
so.
Default
Gateway
Enter the IP address of the default gateway in dotted decimal notation, for example
192.168.1.254.