Filter
Top Products
Chapter 5 EP Management
EOC350 Series User’s Guide
40
Figure 33 Management > Ether > Config > Status (termination adapter)
The following table describes the items in this screen.
5.9 Testing from a Termination Adapter
This section describes the screens used to start diagnostic tests from a termination adapter.
5.9.1 Noise
Follow these steps to measure the noise spectrum at the termination adapter’s coax interface.
Table 30 Management > Ether > Config > Status (termination adapter)
LABEL DESCRIPTION
Status
Link
This shows whether the port is up or down.
Speed/Duplex
This shows the speed and the duplex mode of the Ethernet connection on this port.
Flow Control
This shows whether flow control is enabled on this port.
Statistics
CLEAR
Click this to clear the port traffic statistics.
RxPkt
This shows how many packets have been received by this port.
RxByte
This shows how many bytes have been received by this port.
TxPkt
This shows how many packets have been sent from this port.
TxByte
This shows how many bytes have been sent from this port.
Collision
This shows how many Ethernet collisions have been detected on this port.
Error
This shows how many errors have been detected on this port.
Refresh
Click this to refresh this screen.
Back Click Back to return to the main EP Management screen.