Filter
Top Products
Chapter 11 Telnet
EOC350 Series User’s Guide
62
Only lowercase letters are accepted. Type a command followed by ENTER to execute the
command.
11.2.1.1 EP Default Profile
Run EP commands with the '-m default' parameter to apply settings to the EP Default Profile. This
parameter is not applicable to the 'diag', 'epreg', 'eprestore', 'epstat', 'rmep', 'showep', 'snr', and
'upep' EP commands.
11.2.2 Generic Command Sets
This table describes the generic commands available via the telnet console.
<interface> Network interface name. E.g. 'eth0' for LAN1/LAN2 interface, 'eoc0' for EoC interface.
<fid> The flash ROM file id represents different firmware/driver types, 'n', where n=0~12'.
• n=0: System bootcode (termination system bootloader)
• n=1: System firmware (termination system OS)
• n=2: Termination system EoC driver
• n=3: termination adapter EoC driver
• n=10: termination adapter diagnosis utility
Table 49 Common Telnet Parameters (continued)
PARAMETER DESCRIPTION
Table 50 Generic Telnet Commands
COMMANDS
ARGUMENTS
[ ] IS OPTIONAL
DESCRIPTION
autocfg [-t <on/off>]
[-s <ip or host>]
[-p <path>]
Setup auto configuration by TFTP.
• -t: on (enable) / off (disable) auto
configuration mode
• -s: TFTP server IP address or host name
• -p: directory path resides at TFTP server
dconfig Dump all configurations/settings.
default Reset all settings to factory default, including
passwords.
dhcpsnoop Setup DHCP snooping.
• -m 0: disable (default)
• 1: enable dhcp option 82
• 2: enable dhcp option 82 and snooping
diag -t
-r
-m <mac>
Run a termination adapter connection diagnostics.
This stops all service for 10~20 seconds. We
recommend running the Online Diag command
'snr' first.
• -t: downstream diagnosis (from termination
system to termination adapter)
• -r: upstream diagnosis (from termination
adapter to termination system)
• -m <mac>: termination adapter EoC MAC to
be diagnosed