Filter
Top Products
Chapter 11 Telnet
EOC350 Series User’s Guide
65
passwd [name]
-o <oldpasswd>
-n <newpasswd>
Change user's password. Users can only update
their own password. Only superusers have the
privilege to rewrite the password of other users.
• [name]: user's account name. This defaults to
the current login name if not supplied.
• <oldpasswd>: old password, superuser can
bypass this parameter
• <newpasswd>: new password
ping [-n <count>]
[-w <timeout>]
[-l <pktlen>]
IP address
ICMP ping.
• <count>: number of ping requests (max
65535)
• <timeout>: expiry timer in each reply (1~60
sec)
• <pktlen>: packet length (64~1500)
• IP address: target IP address
reboot Reboot system.
rmep -m <mac> Remove designated termination adapter Properties
Profile.
• <mac>: termination adapter EoC MAC to be
removed
service [-s <telnet/http> [-c <on/off>] [-p
<port)>] [-t <idle>] ]
Display or setup Telnet and Http service
parameters.
• <telnet/http>: configure Telnet or Http
• <on/off>: enable or disable this service
• <port>: TCP port number (0~65535)
• <idle>: expiry timer for automatic logoff
(0~32767 sec) default 300 seconds
showep [-f]
[-n <note>]
[-m <mac>]
Display termination adapter connection status and
properties, and check if it matches the stored
Properties Profile in termination system.
• -f: force re-scan of all connected termination
adapters
• -n: display termination adapter with matching
<note>
• -m: display termination adapter with MAC
address <mac>
showlog Display the (Syslog) logged messages.
showmaster Display termination system EoC information,
including driver version and properties (Privacy
Mode, Privacy Key).
snmp [-c <act/deact>]
[-p <port>]
[-n <name>]
[-t <contact>]
[-l <location>]
[-r <rcomm>]
[-w <wcomm>]
Display or setup basic SNMP system properties.
• <act/deact>: activate (enable) or deactivate
(disable) SNMP agent
• <port>: SNMP UDP port number (0~65535),
default 161
• <name>: SNMP system name
• <contact>: SNMP system contact information
• <location>: SNMP system location information
• <rcomm>: SNMP read-only community name,
default 'public'
• <wcomm>: SNMP read-write community
name, default 'private'
Table 50 Generic Telnet Commands (continued)
COMMANDS
ARGUMENTS
[ ] IS OPTIONAL
DESCRIPTION