Filter
Top Products
Chapter 11 Telnet
EOC350 Series User’s Guide
66
snmptrapserver [-s <set> [-c <act/deact>] [-p
<port>] [-a <ip or host>] [-m
<community>] ]
Display or setup SNMP trap server(s).
• <set>: trap server index, at most 5 servers
(0~4)
• <act/deact>: activate or deactivate trap server
IP <ip>
• <port>: SNMP trap UDP port number
(0~65535), default 162
• <ip>: trap server IP address or host name
• <community>: trap server community name,
default 'public'
snr -m <mac>]
-e <mac>]
[-n <samples>]
[-p <period>]
Start Online Diag over the termination adapter
connection. This will not affect termination adapter
(host) service.
• -m: termination system EoC MAC address
• -e: termination adapter EoC MAC address
• -n: number of samples (default 1 sample)
• -p: period between two samples (default 10
seconds)
sntp [-c <act/deact>]
[-r <refresh time>]
[-z <time zone>]
[-s <set> -a address]
Display or setup SNTP.
• <act/deact>: activate or deactivate SNTP
service for system time
• <refresh time>: query SNTP server period,
default 60 minutes
• <time zone>: '+hh:mm' or '-hh:mm' to GMT
time, hh for hours and mm for minutes, default
'+00:00'
• <set>: registered SNTP server (0~1)
• address: SNTP server host name or IP address
in current set
stat [-r] Display termination system port statistics for port
LAN1/LAN2/EoC.
• -r: reset all port statistics counters to 0
swconfig [-p <lan1/lan2>
[-s <auto /10h /10f /100h /100f>] ]
Display or setup Ethernet port LAN1/LAN2
properties <lan1/lan2>: configure LAN1 or LAN2
port
• <auto>: auto-negotiation mode
• <10h/10f/100h/100f>: 10/100Mbps, half/full-
duplex mode
swigmp [-c <on/off>] Display or setup IGMP v2 snooping on the
termination system
• <on/off>: enable or disable built-in IGMP v2
snooping function, default is off
Table 50 Generic Telnet Commands (continued)
COMMANDS
ARGUMENTS
[ ] IS OPTIONAL
DESCRIPTION