Filter
Top Products
Chapter 11 Telnet
EOC350 Series User’s Guide
63
dir Show details of files in the flash ROM, including the
working area and upload area. The listed
filenames are:
• bootcode: boot loader
• sysfw4m: system firmware
•G2C44H2xM: termination system EoC driver
• G2C44H2xEp: EP(3210) EoC driver
• G3C1244xEp: EP(3310) EoC driver
• diagsw: diagnosis utility file
Details shown include the file id, file version, file
date, and file size.
dns [-s <pri/sec> <ip>] Display or setup DNS server settings.
• -s pri <ip>: setup Primary DNS server's IP
• -s sec <ip>: setup Secondary DNS server's IP
exit Close the Telnet console.
quit Close the Telnet console.
ep [-c <hostcnt>]
[-n <note>]
-m <mac>
Setup termination adapter EoC properties.
• <hostcnt>: termination adapter Host Limit
(0~12), default 3
• <note>: termination adapter Note
• <mac>: The EoC MAC address of the
termination adapter being configured.
ephpnareboot -m <mac> Reset termination adapter EoC device
epreg -m <mac> Add a termination adapter profile, (like Add EP in
the Web Configurator)
eprestore -m <mac> Apply termination adapter EoC/Ethernet properties
(settings in termination system) to a termination
adapter, (like ReConfig EP in the Web
Configurator).
epstat -m <mac>
[-r]
Display termination adapter LAN1/LAN2/EoC port
statistics.
• -r: reset all port statistics counters to 0.
epswc -m <mac>
[-t]
[-u]
[-r]
[-d]
[-p <lan1/lan2/hpna> [-l <up/
down>] [-s <auto /10h /10f /100h /
100f>] [-f <on/off>]]
Display or setup the Ethernet properties of a
termination adapter’s built-in switch.
• -t: display termination adapter switch settings
• -u: display termination adapter switch/port
status
• -r: reset termination adapter switch
• -d: reset termination adapter switch settings to
factory defaults
• -p: configure termination adapter LAN1/LAN2/
EoC port
• -l: link, <up/down>: force current port to link
up or down, i.e. enable/disable current port
• -s: current port Ethernet mode setting,
<auto>: auto-negotiation mode
<10h/10f/100h/100f>: 10/100Mbps, half/full-
duplex mode
• -f: current port Ethernet flow-control setting,
<on/off>: turn on /off flow control
Table 50 Generic Telnet Commands (continued)
COMMANDS
ARGUMENTS
[ ] IS OPTIONAL
DESCRIPTION