
24
Using the Main Menu
• Press + enable/disable motion sensitivity.
Disabled blocks are colored
grey
. Active
blocks will be
turquoise-colored
when motion
is detected. Move an object in front of the
selected camera to test sensitivity and
enable/disable the appropriate blocks
• Press
- to exit the grid
• Press WX to se
lect All/Clear
and then press
+.
6. Press ENTER to save your
settings. Press
CANCEL/ESC
to close remaining menu
windows.
RECORD
Configure recording parameters for
each channel.
To configure recording settings:
1. Press
ST to select a camera.
2. Press
WX to select an option and the
press
+ / - to configure the following:
• USE: Select ON/OFF. If OFF, the selected
camera(s) will not record.
• QUALITY: Sel
ect LOW, MIDDLE, HIGH,
SUPER, and ULTRA.
• RATE: Sel
ect 1, 2, 3, 4, 5, 6, 7, 10, or 15 fps.
• AUDIO: Sele
ct ON/OFF. Audio capable
cameras or microphones are required for
audio recording.
• MO
TION: Sel
ect ON/OFF. Motion Grid and
sensitivity must be configured in the Motion
menu. See “MOTION” on page 23.
3. Press ENTER to save your settings. Press
CANCEL/ESC to close remaining menu
windows.
ALARM
Configure recording parameters for
alarm recording.
NOTE: An external alarm device is not included
with the system.
To configure alarm settings:
1. Under RECORD SETUP, press
ST to
select a camera. Press
WX to select an
option and press
+ / - to configure the
following:
• USE: Select ON/OFF. If OFF, the selected
camera(s) will not record.
• QUALITY: Sel
ect LOW, MIDDLE, HIGH,
SUPER, and ULTRA.
• RATE: Sel
ect 1, 2, 3, 4, 5, 6, 7, 10, or 15 fps.
• AUDIO: Sel
ect ON/OFF. The number of audio
input channels varies by model.
• INPUT: Sele
ct N.O/
N.C.
TIP!
When you have
configured settings for
one camera, press
to apply the settings for
the rest of the cameras!