Filter
Top Products
121
PD-6
DVD Location Recorder (Chapter 8: Utility mode)
Setting IEEE1394 connection [IEEE1394]
Using the “IEEE1394” menu, you can select “CONNECT” or “DISCONNECT” of
the IEEE1394 connection.
By selecting “CONNECT”, the [IEEE1394] connector can be used to connect
the PD-6 to a personal computer, and you can control the PD-6 drive from
the computer.
<Note>
When “CONNECT” is selected, the PD-6 drive cannot be controlled from the panel
keys.
1. Select the “IEEE1394: ****” menu and press the [ENTER] key.
The current option (“CONNECT” or “DISCONNECT”) flashes (the default is
“DISCONNECT”).
2. Use the [SEL] dial to select “DISCONNECT” or “CONNECT”, and press the
[ENTER] key to confirm the setting.
3. Press the [EXIT] key to exit the Utility mode.
If you exit the Utility mode after setting this menu to “CONNECT”, “Selected!—
IEEE1394—” is shown on the display.
<Note>
To disconnect the IEEE1394 connection, go to the “IEEE1394” menu again
and select “DISCONNECT”.
flashing