Filter
Top Products
82
PD-6
DVD Location Recorder (Chapter 6: TC Setup mode)
flashing
How to select the TC Setup menu
1. When the [SHIFT] indicator is lit, press the [CONTRAST/TC SETUP] key.
The PD-6 enters the TC Setup mode, while the display shows the TC SETUP
screen as below by default.
This screen is the primary layer screen and shows the menu list.
Some menu has “
” on the right. This indicates you can enter the dedicated
screen of the menu.
2. Select the desired menu using the [SEL] dial and press the [ENTER] key.
You can now set or edit the selected menu.
In the following description, we assume that the TC SETUP (primary) screen is
shown on the display.
Editing the LTC start time
You can set the desired LTC start time corresponding to the beginning (ABS
0) of an audio file.
<Note>
PD-6 records only the start time of LTC, and the internal generator generates and
outputs LTC with reference to the start time.
With a “BWF” file, the start time is recorded as “Time Reference” in “Broadcast
Audio Extension Chunk”.
1. Select the “Edit LTC start ” menu and press the [ENTER] key.
The current LTC start time is shown.
If you just check the current LTC start time without editing the time, press the
[EXIT] key to exit the TC Setup mode. To edit the LTC start time, go to the next
procedure.
2. Press the [ENTER] key.
Initially, the subframe value flashes and you can now edit the subframe of LTC
start time.