Filter
Top Products
83
PD-6
DVD Location Recorder (Chapter 6: TC Setup mode)
On
Off
flashing
3. Use the [SEL] dial (or the numeric keys) to enter the desired start time.
You can select the flashing digit (to be edited) using the [ SKIP/CURSOR ]
keys. The start time can be set between “00H: 00M: 00S: 00F: 00SF” and “23H:
59M: 59S: **F: 99SF” (** is one less than the frame rate value).
4. After editing the start time, press the [ENTER] key to confirm the setting.
5. Press the [EXIT] key to exit the TC Setup mode.
You can see the edited LTC start time reflected when switching the display to
“LTC”.
Time code output while paused
This menu select whether time code is output from the [TIME CODE OUT]
connector or not while the recorder is paused.
1. Select the “Pause TC: ***” menu and press the [ENTER] key.
The current setting (“On” or “Off”) flashes (the default setting is “Off”).
2. Use the [SEL] dial to select “On” or “Off” and press the [ENTER] key to confirm
the selection.
When the [TC OUT] select switch is set to “REPRO” and the recorder is stopped
(or paused), time code of the same value is output intermittently.
When the [TC OUT] select switch is set to “REPRO” and the recorder is stopped
(or paused), no time code is output.
3. Press the [EXIT] key to exit the TC Setup mode.