Filter
Top Products
77
PD-6
DVD Location Recorder (Chapter 5: Recording/playback)
• When playing back either one of two files recorded in the “2+4” mode
• When playing back either one of two files recorded in the “1+5” mode
“2+4”
position
Other than “2+4”
position
“1+5”
position
Other than “1+5”
position
• Playback of a file recorded in two-file mode
When playing back either one of two files recorded in two-file mode (“2+4” or “1+5”),
the output assignment of the [ANALOG LINE OUT] connectors depends on the [REC
TR] select switch position. The following table shows the relation between the track
numbers (TR1 through TR6) of [ANALOG LINE OUT] connectors and the [REC TR]
select switch position for each mode.
When playing back the 2-track file, the signals are output from the “TR1” and “TR2”
connectors.
When playing back the 4-track file, the signals are output from the “TR3” through “TR6”
connectors.
When playing back the 2-track file, the signals are output from the “TR1” and “TR2”
connectors.
When playing back the 4-track file, the signals are output from the “TR1” through “TR4”
connectors.
When playing back the mono-track file, the signal is output from the “TR1” connector.
When playing back the 5-track file, the signals are output from the “TR2” through “TR6”
connectors.
When playing back the mono-track file, the signal is output from the “TR1” connectors.
When playing back the 5-track file, the signals are output from the “TR1” through “TR5”
connectors.
<Note>
You cannot play back both of two files recorded in two-file mode simultaneously.
Time code playback
Recorded time code is played back together with audio and can be output
from the [TIME CODE OUT] connector.
To output recorded time code from the [TIME CODE OUT] connector, set the
[TC OUT] switch on the top panel to “REPRO”.
You can also make setting of the following menus in the TC Setup mode
according to the situation.
1. LTC start time setting (using the “Edit LTC start” menu)
2. TC output setting while paused (using the “Pause TC” menu)
3. Repro TC user bit setting (using the “TC Ubit” menu)
* See “Chapter 6: TC Setup mode” on page 81 for details about the TC Setup
mode.
Cueing playback
In the cue mode, forward or backward cueing (at up to 2 x speed) is possible.
During playback, pressing the [F FWD] (or [REW]) key enters the cue mode.
The cueing speed gradually gets faster unit it reaches the 2 x speed.
To cancel the cue mode, press the [PLAY] mode.
<Note>
If the [TC OUT] switch is set to “GEN”, always the internal TC generator time code
is output from the [TIME CODE OUT] connector.