Filter
Top Products
96
PD-6
DVD Location Recorder (Chapter 7: Setup mode)
Off
Option
Comment
On (default)
Off
Option Comment
On (default)
Off
Option
Comment
On (default)
flashing
Error tone output setting (Error tone)
The “Error tone” menu selects whether generating the error tone (warning tone) or
not for each of four kinds of troubles (see below) independently. The error tone is
generated from the internal monitor speaker (or headphones).
On the “Error tone” menu screen, you can select “On” or “Off” of the error tone for
“Write error”, “Input clip” and “BATT warning”, as well as can set the time for “Disk
warning”.
<Available conditions for generating the error tone>
The name in the bracket at the end of each condition shows each item name of the Error
tone menu.
1. A write error happens during recording. [Write error]
2. The peak indicator lights because of the input overload during recording. [Input
clip]
3. The internal battery voltage drops below the level set by the “BATT warning” menu.
[BATT warning]
4. The remaining recording time of a disk gets under the specified time. [Disk warning]
When the peak indicator lights because of the input overload during
recording, the error tone is not generated.
When the peak indicator lights because of the input overload during
recording, the error tone is generated.
<Write error>
<Input clip>
When the peak indicator lights continuously because of the input overload,
the error tone is not generated.
When the peak indicator lights continuously because of the input overload,
the error tone is generated.
<BATT warning>
When the internal battery voltage drops below the level set by the “BATT
warning” menu, the error tone is not generated.
When the internal battery voltage drops below the level set by the “BATT
warning” menu, the error tone is generated.