Filter
Top Products
81
PD-6
DVD Location Recorder (Chapter 6: TC Setup mode)
Chapter 6: TC Setup mode
This chapter describes details about each menu available in the TC Setup mode. In the TC Setup
mode, you can:
1. Check and edit the LTC start reference time at ABS 0.
2. Select whether the PD-6 outputs time code or not while the recorder is paused.
3. Select user bit of output time code when the [TC OUT] switch is set to “REPRO”.
4. Check the internal time code generator status and edit the start time and user bit.
5. Select the user bit of output time code when the [TC OUT] switch is set to “GEN”.
6. Set the jam mode when the internal time code generator is in the “FREE RUN” mode.
<Table of contents>
How to select the TC Setup menu .............................................................................................................82
Editing the LTC start time ..........................................................................................................................82
Time code output while paused ...............................................................................................................83
User bit setting of playback time code ....................................................................................................84
Editing the internal time code generator setting ...................................................................................85
User bit setting of internal generator time code .....................................................................................86
Jam mode setting .......................................................................................................................................86