Filter
Top Products
23
PD-6
DVD Location Recorder (Chapter 2: Before using the PD-6)
2
3 1
<Figure-1>
<Figure-2>
Inserting / removing a disk
You can insert or remove a disk regardless of whether the power is on or off,
however, the procedure below is assumed that the power is on.
1) Slide the [OPEN] lever right and open the protection cover manually.
2) Press the [DISC UNLOCK] button to release the tray lock.
When the power is off, you do not have to do this.
3) Slide the [EJECT] lever to open the tray.
4) Set (or remove) a DVD-RAM disk to (or from) the tray and press the upper part
of the tray to close the tray.
If you set an unused disk, the display shows the screen for prompting disk
formatting.
<Note>
When inserting a disk to the tray, make sure that the
direction is right.
<Notes>
When setting an unused new disk, the message as
shown in <Figure 1> appears after reading the disk
information, prompting that disk formatting is
required.
An unused disk may not be formatted with the UDF
format Rev 1.5 or may not have the BWF directory,
therefore, it must be formatted with UDF Rev1.5
format.
When an unformatted disk or a disk which is not
formatted in UDF format is set, the PD-6
automatically brings up the “Format” menu (see
<Figure 2>) in the Utility mode after reading the
disk information. This shows the disk is not UDF-
formatted and must be formatted with UDF Rev1.5.
If you do not format the disk, press the [EXIT] key.
The PD-6 releases the disk from locking so that you
can remove the disk from the tray.
<Note>
Depending on the condition when you turned off the power
last time, the disk lock may not be released on rare occa-
sions . In such a case, turn off and on the power, then press
the [DISC UNLOCK] button again to release the disk lock.