Filter
Top Products
90
PD-6
DVD Location Recorder (Chapter 7: Setup mode)
flashing
Cursor position Cursor position
Value range Value range
“y” (year)
“m” (month)
“d” (day)
“H” (hour)
“M” (minute)
“S” (second)
00 ~ 99
01 ~ 12
01 ~ 31
00 ~ 23
00 ~ 59
00 ~ 59
How to make Setup menu setting
Some Setup menus have the dedicated screens for editing, while others do
not have the dedicated screens and can be edited on the primary screen.
A menu of the former type has “ ” on the right, while a menu of the latter
type does not have “ ”.
The following describes how to make settings of the “Adjust RTC” and “Digital
out” menus as the examples of the former and latter types, respectively.
You can make editing of each menu by the similar procedure as either of
these examples.
Adjusting the real-time clock (Adjust RTC)
The “Adjust RTC” menu allows you to check and edit real-time clock data.
1. Select the “Adjust RTC ” menu and press the [ENTER] key.
The display changes to show the screen on which the current real-time clock is
shown.
2. To edit the current clock data, press the [ENTER] again.
The second digits in the clock data flash. You are now able to edit the clock
data.
3. Use the [SEL] dial (or the numeric keys) to enter the desired value at the cursor
(flashing) position.
You can move the cursor position using the [ SKIP/CURSOR ] keys.
For each digit, you can enter the value within the range shown below.
4. After editing the clock data, press the [ENTER] key to make the editing effective.
<Note>
To set the clock precisely, set the clock data to a near future time and press
the [ENTER] key synchronizing with the time signal.
5. Press the [EXIT] key to exit the Setup mode.