Filter
Top Products
137
PD-6
DVD Location Recorder (Exporting files using IEEE1394)
<Note>
In the following procedure, we assume that a recorded DVD-RAM disk is
set to the PD-6 and an audio file is loaded. If no disk is set or the door is
not locked, you cannot make the “IEEE1394” menu setting in the Utility
mode.
Connection between the PD-6 and a PC
How to disconnect the PD-6
1) Set the “IEEE1394” menu in the Utility mode to “CONNECT”, and turn off the
PD-6 power (the menu setting is memorized even if the PD-6 is turned off).
Then, connect between the PD-6 and the PC using an IEEE1394 cable, and turn
on the PD-6 power.
2) While the PD-6 power is off, connect between the PD-6 and the PC using an
IEEE1394 cable, and then turn on the PD-6 power while holding down the [SHIFT]
key (the “IEEE1394” menu is automatically set to “CONNECT”).
Use either method (1 or 2) below for connecting the PD-6 to a PC.
It is assumed that the PC has already started up in the following description.
To disconnect the PD-6 from the PC, make the PC ready for disconnecting
the PD-6, and disconnect the IEEE1394 cable, then set the “IEEE1394” menu
to “DISCONNECT”.
The procedure for making the PC ready for disconnecting the PD-6 differs
depending on the PC. Please refer to the instructions of the PC.
If you turn off the PD-6 power with the “IEEE1394” menu set to “CONNECT”
and then turn it on next time, the PD-6 starts up with the “CONNECT” set-
ting. Therefore, by repeating the procedure below, you can easily connect
more than one disk to the PC.
1) Turn off the PD-6 power with the “IEEE1394” menu set to “CONNECT”.
2) Change a disk and turn on the PD-6 power again.
3) After “Selected --IEEE1394--” is shown on the display, connect the cable.
4) After copying the disk contents to the PC, make the PC ready for
disconnecting the PD-6, and disconnect the cable.