Filter
Top Products
188 iRMC S2/S3
Power Management
Boot Options
The Boot Options group allows you to configure the behavior of the system the
next time it is booted. You can set whether the BIOS is to interrupt the boot
process for the system if errors occur during the POST phase.
I The options set here only apply to the next boot operation. After this, the
default mechanism applies again.
Figure 101: Power Management - Boot Options page
Ê Select the desired BIOS behavior from the Error Halt Settings list:
Continue
Continue the boot process if errors occur during the POST phase.
Halt on errors
Interrupt the boot process if errors occur during the POST phase.
Ê From the Boot Device Selector list, select the storage medium you wish to boot
from.
The following options are available:
– No change: The system is booted from the same storage medium as
previously.
– PXE/iSCSI: The system is booted from PXE/iSCSI over the network.
– Harddrive: The system is booted from hard disk.
– CDROM/DVD: The system is booted from CD /DVD.
– Floppy: The system is booted from floppy disk.
Ê Click Apply to activate your settings.