Filter
Top Products
iRMC S2/S3 241
Network Settings - Configure the LAN parameters
IPv4 Enabled
Enables/disables IPv4 addressing for the iRMC S2/S3. If IPv4
addressing is enabled, the IPv4 configuration group will be displayed (see
below).
You cannot disable IPv4 addressing if the iRMC S2/S3 is currently
accessed via IPv4.
IPv6 Enabled
Enables/disables IPv6 addressing for the iRMC S2/S3. If IPv6
addressing is enabled, the IPv6 configuration group will be displayed (see
below).
You cannot disable IPv6 addressing if the iRMC S2/S3 is currently
accessed via IPv6.
IPv4 configuration
The IPv4 configuration group allows you to configure the IPv4 settings for the
iRMC S2/S3.
IP Address
IPv4 address of the iRMC S2/S3 in the LAN. This address is different
from the IP address of the managed server.
I If you are working with a static address (DHCP enable option not
activated) then you can enter this here. Otherwise (if the
DHCP enable option is activated), the iRMC S2/S3 only uses the
field to display the address.
Subnet Mask
Subnet mask of the iRMC S2/S3 in the LAN.
Gateway
IPv4 address of the default gateway in the LAN.
DHCP Enabled
If you activate this option, the iRMC S2/S3 gets its LAN settings from a
DHCP server on the network.
I Do not activate the DHCP option if no DHCP server is available on
the network.
If you activate the DHCP option and there is no DHCP server
available on the network, the iRMC S2/S3 goes into a search loop
(i.e. it continues searching for a DHCP server until it finds one).