Filter
Top Products
38 iRMC S2/S3
iRMC S2/S3 factory defaults
2.2 iRMC S2/S3 factory defaults
The firmware of the iRMC S2/S3 provides a default administrator ID and a
default DHCP name for the iRMC S2/S3.
Default administrator ID:
I Both the administrator ID and the password are case-sensitive.
For reasons of security, it is recommended that you create a new
administrator account once you have logged in, and then delete the
default administrator account or at least change the password for the
account (see section "User Management" on page 263).
Default DHCP name of the iRMC S2/S3
The default DHCP name of the iRMC S2/S3 uses the following pattern:
IRMC<SerialNumber>
I The serial number corresponds to the last 3 bytes of the MAC address of
the iRMC S2/S3. You can take the MAC address of the iRMC S2/S3 from
the label on your PRIMERGY server.
After you have logged in, the MAC address of the iRMC S2/S3 can be
found as a read-only entry above the fields on the page Network Interface
(see page 239).
Administrator ID: admin
Password: admin