Filter
Top Products
iRMC S2/S3 45
Configuring the LAN interface of the iRMC S2/S3
Ê Configure the following settings:
Service LAN
Set the value to Enabled.
Service LAN Port
The Service setting is recommended.
I The Service setting is mandatory for the Type TX150 S6
PRIMERGY server.
DHCP
If you enable DHCP, the iRMC S2 gets its LAN settings autonomously
from a DHCP server on the network. In this case, the values for Local
IP Address, Subnet Mask, etc. are set automatically.
I Do not activate the DHCP option if no DHCP server is
available. If you activate the DHCP option and there is no
DHCP server available, the iRMC S2 goes into a search loop
(i.e. it constantly searches for a DHCP server).You can specify
that the DHCP and DNS services are to be used after initial
installation, using the iRMC S2 web interface, for instance (see
section "DNS Configuration - Configuring DNS for the
iRMC S2/S3" on page 249).
By default, the following name is passed to the DHCP server
on initial installation of the iRMC S3:
iRMC<last 3 bytes of the MAC address>.
Local IP Address
Enter the IP address you have determined for the iRMC S2 of the
managed system.
Subnet Mask
Enter the subnet mask for the network. the iRMC S2 is connected to.
Gateway Address
Specify the IP address of the gateway of the network the iRMC S2 is
connected to.
Ê Save the settings.