Filter
Top Products
242 iRMC S2/S3
Network Settings - Configure the LAN parameters
The (configured) iRMC S2/S3 can be registered with a DNS
server by an appropriately configured DHCP server (see section
"DNS Configuration - Configuring DNS for the iRMC S2/S3" on
page 249).
IPv6 configuration
The IPv6 configuration group allows you to manually configure an IPv6 address
for the iRMC S2/S3 in addition to the link-local address, which is always
assigned automatically to the iRMC S2/S3 by using stateless autoconfiguration.
I With ipv6 addressing, DHCP is not supported for the iRMC S2/S3.
Figure 137: Network Interface page - manual IPv6 configuration disabled
Manual IPv6 configuration
This option is disabled by default.
If you enable the Manual IPv6 configuration option, the IPv6 configuration
group displays additional parameters that allow you to manually
configure a routable IPv6 address for the iRMC S2/S3:
Figure 138: Network Interface page - manual IPv6 configuration
Interface Identifier Source
Specifies from which source the interface identifier part of the IPv6
address is taken.