Filter
Top Products
hp dvd-writer
hp dvd-writerhp dvd-writer
hp dvd-writer
dvd100i
dvd100idvd100i
dvd100i
Technical Support Solutions Guide 10/25/01 Physical Specifications
19
1919
19
⇐
⇐⇐
⇐
⇒
⇒⇒
⇒
Connector and Jumpers on hp dvd-writer dvd100i Drive
Back of Drive
Back of DriveBack of Drive
Back of Drive
Figure 4
Figure 4 Figure 4
Figure 4 Back of Internal IDE Drive
Power Connector
Power ConnectorPower Connector
Power Connector
The hp dvd-writer dvd100i drive is an internal drive. The drive shares power from the
PC power supply. The drive has an industry standard 4-pin Amphenol or compatible
male power connector, capable of housing 18 AWG wires for each connector pin.
Figure 5
Figure 5 Figure 5
Figure 5 DC Power Connector
Signal Connector
Signal Connector Signal Connector
Signal Connector
The signal connection on the hp dvd-writer dvd100i drive is a 40-pin header
connector with a key slotted shroud. Additionally pin 20 has been removed from the
connector for keying as shown in Figure 6.
Figure 6
Figure 6 Figure 6
Figure 6 Interface Connector
The cable is a 40 conductor (stranded 28 AWG) flat ribbon cable with female header
type connectors. The maximum cable length is 18 inches. The female header type
connectors that connect to the drive has a plastic extrusion on the side of the
connector by pins 19 and 21. This allows the cable to correctly mate with the key
slotted shroud connector on the drive.
Table 12 on page 20 gives a list of the signals and connector pinout required for an
ATA-2 interface. The signals listed in Table 12 are shown as single-ended contact
assignments and not differential.
DIGITAL
AUDIO
R GND L
PIN
#
1
DC INPUTIDE
CONNECTOR
5V GND
12V
CABLE SELECT
SLAVE
MASTER
ANALOG
AUDIO
OUT
D G
OUT
Pin DC Volts
1
2
3
4
+12 V
GND
GND
+5 V
Missing Pin 20 (key pin)
Product Information Drive Specifications Interfaces Installation and Configuration
Drive Operation Tips and Techniques Software Maintenance
Troubleshooting Warranty and Support Release Notes Discontinued Products