Filter
Top Products
hp dvd-writer
hp dvd-writerhp dvd-writer
hp dvd-writer
dvd100i
dvd100idvd100i
dvd100i
Technical Support Solutions Guide 10/25/01 Installing the hp dvd-writer dvd100i Drive
38
3838
38
⇐
⇐⇐
⇐
⇒
⇒⇒
⇒
8.
8.8.
8. Look at the Install Recommendation printout to see whether the jumper should
be set to the Master or Slave position, then set the jumper on the back of the
hp dvd-writer drive to the recommended position.
NOTE:
NOTE: NOTE:
NOTE:
Jumpers are small caps that fit over pairs of pins on the back of the
hp dvd-writer drive. Jumpers can be pulled off or replaced with needle-
nose pliers.
Figure 18
Figure 18 Figure 18
Figure 18 Setting Jumpers on the Drive
9.
9.9.
9. If your computer uses rails, attach the rails that came with the computer to the
sides of the hp dvd-writer dvd100i drive (see Figure 19).
Some computers use rails instead of screws to hold the drive in place.
NOTE:
NOTE: NOTE:
NOTE:
You can tell if your computer uses rails by looking at the other drives
installed in your computer.
Figure 19
Figure 19 Figure 19
Figure 19 Rails for Mounting the Drive
10.
10.10.
10. Slide the hp dvd-writer drive partially into the bay.
Product Information Drive Specifications Interfaces Installation and Configuration
Drive Operation Tips and Techniques Software Maintenance
Troubleshooting Warranty and Support Release Notes Discontinued Products