HP (Hewlett-Packard) DVD100I DVD Recorder User Manual


 
hp dvd-writer
hp dvd-writerhp dvd-writer
hp dvd-writer
dvd100i
dvd100idvd100i
dvd100i
Technical Support Solutions Guide 10/25/01 IDE Connectors
32
3232
32
IDE Connectors
When you place Software Disc 1 in your CD-ROM and click
Install
Install Install
Install hp dvd-writer
hp dvd-writer hp dvd-writer
hp dvd-writer
the
software analyzes your computer and makes a recommendation about connecting
the hp dvd-writer hardware.
The Install Recommendation tells you whether the hp dvd-writer should be
connected to the primary or secondary controller in your computer.
NOTE:
NOTE: NOTE:
NOTE:
If the Install Recommendation states that your hp dvd-writer drive will
share the data cable with another device (such as a CD-ROM drive), follow
the cable already attached to the other device down to the circuit board in
order to locate the IDE controller that you need. If you find an extra
connector along that cable, simply attach that connector to the
hp dvd-writer drive.
Locate the recommended 40-pin IDE controller’s connector (primary or secondary)
on your computer’s motherboard.
The IDE connectors are on the motherboard, which is the largest circuit board in your
computer, taking up most of the bottom of a desktop computer or the side of a tower
computer.
IDE connectors are usually found in pairs and may look like any of the following:
Figure 10
Figure 10 Figure 10
Figure 10 IDE Connectors
You will see a variety of connectors inside your computer that look similar to the
40-pin connector, but have more or fewer pins. Find the connectors that are the
correct size to fit the cable that came in the box with your drive.
Figure 11
Figure 11 Figure 11
Figure 11 40-Pin IDE Connector
The IDE connectors may be hidden by some of the computer’s cables or may be
behind a drive.
Many computers have an IDE hard drive or CD-ROM that connects to the
motherboard through an IDE controller. The data cables on these drives have the
same width as the data cable included with your hp dvd-writer. If your computer has
an IDE hard drive or CD-ROM drive, you can follow the data cable from the back of
one of those drives to find the IDE controller.
Computer manufacturers use a wide variety of labels for IDE connectors. Look on
your computer’s circuit boards for printing identifying the primary and secondary
connectors, such as:
- PRI and SEC
- IDE-0 and IDE-1
- IDE-1 and IDE-2
- HD and CD-ROM (most common devices to be attached)
- PCI-IDE and ISA-IDE
Product Information Drive Specifications Interfaces Installation and Configuration
Drive Operation Tips and Techniques Software Maintenance
Troubleshooting Warranty and Support Release Notes Discontinued Products