Filter
Top Products
Using Other External Devices
64
The VR-509 allows connection of one external hard disk drives
in addition to the 2 built-in hard disks. Follow the procedure
below to alter the connection setup of the hard disk. There are
3 ways of altering connection setup, namely “NEW”,
“CHANGE” and “DISCONNECT”.
1. Switch off the power.
• Switch off the power to the VR-509 by observing the
instructions provided in the section on “Switching Off the
Power” in Switching the Power ON/OFF. (Page 16)
• External hard disks will not respond to any operations
when the VR-509 is in the OPERATION OFF mode.
Disconnect the power cable and then reboot the system.
2. Connect the external hard disk to the [SERIAL] port on
the front or on the back panel and then plug in the
power cable.
• Make sure the power to the external hard disk is switched
on before switching on the power to the VR-509.
Note that it is necessary to switch on the power to the
external hard disk that was first connected, otherwise
additional hard disks will not be recognized.
3. Switch on VR-509.
• The HDD reconfiguration confirmation screen will be
displayed.
4. Select [EXEC], and then press the [SET] button.
• The HDD reconfiguration confirmation screen will be
displayed.
5. Select [EXEC] and then press the [SET] button once
again.
• The external hard disk will be formatted.
• The FORMATTING SUCCESSFUL screen will be
displayed when the process has been completed. The
system will then automatically return to normal
operations.
• The disconnection process will be performed instead of
the formatting process if it is disconnected.
UPS: Uninterruptible Power Supply
Connecting a UPS to the hard disk will protect it from damage
by automatically powering down all operations prior to
switching off the power supply.
1. Connection
• Connect the UPS communication cable to the [SERIAL]
port on the front or rear panel.
• Connect the VR-509 power cord to the UPS power
output connector.
2. Switching on the power
• Switch on the power to the UPS.
• Switch on the power to the VR-509.
External Hard Disk Drives
* It is impossible to disconnect an external hard disk from
the VR-509 and connect it to a personal computer in order
to view the images.
* Consult with your nearest JVC dealer for details on the
external hard disks that can be used.
* It is recommended that a UPS is used to ensure system
safety.
Connecting a UPS
* Make sure the UPS communication cable is connected
before switching on the power to the VR-509.
* Do not disconnect the communication cable when
operations are being carried out.
* Consult with your nearest JVC dealer for details on the
UPS that can be used.
A USB hub is required when a UPS and an external hard
disk are to be used simultaneously.
Make sure that the USB hub supports USB 2.0.
Depending on the USB hub in use, there is a chance that
USB 1.1 will be operated in the event of both USB 2.0 and
USB 1.1 equipment being connected. It is recommended
that this type of USB hub is avoided.
USB Hub