Filter
Top Products
32
•••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
•
♦ Connected SCSI device
The SCSI ID number of connected devices can be con-
firmed on the screen.
1. Press the INFO button.
• The <INFORMATION> menu appears.
2. Turn the JOG dial until the cursor is next to “CONNECTED
SCSI DEVICE” and turn the SHUTTLE ring to the right.
• SCSI ID numbers are shown on the screen.
<CONNECTED SCSI DEVICE>
SCSI ID0:HDD(30GB)
ID1:HDD( 9GB)
ID2:NONE
ID3:NONE
ID4:DDS
ID5:NONE
LIMIT OFF
3. Turn the SHUTTLE ring to the left or press the INFO button.
■ Elapsed time display
The elapsed time of main HDD, archive device and copy
device are shown on the screen. ELAPSED TIME for AR-
CHIVE or COPY will not be displayed unless an ARCHIVE
device or COPY device has been connected to the unit.
The elapsed time of main HDD is counted while
the unit’s power is turned on.
The elapsed time of the peripheral device (ID4) is
counted as shown below:
1) While the ARCHIVE button illuminates or flashes.
<ELAPSED TIME>
MAIN 1500H
ARCHIVE 200H
COPY 120H
2) While the PLAY or REV PLAY button illuminates
or flashes when the archive device is selected as a
playback device using the PLAY DEVICE button.
Refer to page 14,” Basic playback” for details.
3) While the ARCHIVE indicator illuminates or
flashes when restoring the data from main HDD to
archive device.
The elapsed time of the peripheral device (ID5)
is counted as shown below.
1) While the PLAY or REV PLAY button illuminates
or flashes when the copy device is selected as a
playback device using the PLAY DEVICE button. Re-
fer to page 14, ” Basic playback” for details.
2) While the COPY indicator illuminates or flashes
when copying the data from main HDD to the copy
device.
3) While the COPY indicator illuminates or flashes
when restoring the data from main HDD to the copy
device.
1. Press the INFO button.
• The elapsed time is shown on the lower part of the screen.
2. After confirming the elapsed time, turn the SHUTTLE ring
to the left.
• To exit the menu, press the INFO button again.
• The elapsed time of archive device or copy device will not
be reset even though those devices are disconnected.
• The elapsed time of archive device includes the time when
the ARCHIVE button is pressed (when pressed, the ARCHIVE
button illuminates) even in the case where there is no data
on the main HDD such as an alarm stand-by mode.
• The elapsed time shown on this menu may not be consistent
with the regulation guaranteed period of the stock of wearing
parts subject to wear or the guaranteed life span.
INFORMATION
The elapsed time is shown up to
999999 hours at the maximum.
Various settings (continued)