Filter
Top Products
8
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
•
Major operations and their functions (continued)
CLOCK ADJ
REC
POWER ON
POWER OFF
ALARM OUT
MODE OUT
CALL OUT
CALL OUT GND
GND
DC 5V OUT
MAX 30mA
1
MIC
IN
OUT
23456789
1
RS-232C
234
1
GND
23456789
CAMERA IN
AUDIO
CAMERA OUT
ALARM IN
56789
ON OFF
SCSI
Y/C
VIDEO
OUT
GND
GND
GND
1
3
5
6
2
4
7
8
9
10 11
RESET
SCSI
TERMINATION
1. AUDIO connectors
AUDIO IN connector
Input connector for audio signal (RCA pin).
AUDIO OUT connector
Output connector for audio signal (RCA pin).
2. MIC jack
Input connector for microphone (600 ohm imped-
ance).
3. CAMERA IN connectors
Input connector for images of camera (BNC con-
nector).
4. CAMERA OUT connectors
Output connector for images of camera which is in-
putted into CAMERA IN (BNC connector).
5. VIDEO OUT connectors
Output connector for video signal (BNC connector).
S(Y/C) OUT connector
Output connector for separate Luminance and
Chrominance signal. Available to output the signal
with VIDEO OUT connector at the same time.
6. AC power socket
This socket connects to the power cord. Earth ter-
minal is for safety. Use the 100 - 240V plug with
earth for the power of this unit. (Refer to #1)
■ Rear View
7. RS-232C socket
This terminal is used to connect to host device
with RS-232C terminal. This unit can be control-
led by the other device through this terminal.
8. ALARM IN terminals
Input terminal for alarm signal.
GND terminals
Input earth terminal for ALARM IN terminal. Use
only the terminal screw for this unit. It may cause
damage or poor connection.
9. I/O terminals
Refer to the marginal notes on right side.
10. SCSI terminal
This terminal is for connecting this unit to other
peripheral recording devices.
11. RESET button
When pressed, the present time is erased and ini-
tialized, then the power is turned off.
SCSI TERMINATION switch
When setting to “ON”, the terminator function
works, and when setting to “OFF”, the function
stops. Set it to “ON” when not connecting the pe-
ripheral SCSI device.